来源:本站 时间:2019-03-16 11:52:13 浏览次数: 346
安装前要确保TUBE管连接端的表面没有缺陷(无凹陷、凸起或刮痕等),端面经切割和平口成90度,并且去除了管内外毛刺。
Before installation, ensure that the surface of the TUBE connection is free from defects (no dents, bumps, scratches, etc.), that the end face is cut to 90 degrees from the surface of the mouth, and that the internal and external burrs of the TUBE are removed.
(1)需要连接的VCR组件。
(2)分别将外螺纹螺母(Male Nut)和内螺纹螺母(Female Nut)套在接头(Gland)上,然后分别同需要连接的TUBE管自动焊接。
(3)安装金属垫片:如果是带爪垫片,将垫片卡在Gland上(注意不要划伤Gland的密封面);如果是无爪垫片,将垫片放进Female Nut内。
(4)用手指拧紧内、外螺母。
(5)用记号笔在内、外螺母的六角头上划线做记号(如图6)。
(6)用一个扳手固定外螺纹螺母,另一个扳手向内拧紧内螺纹螺母1/4圈(即90度)。
Installation steps of VCR connector:
(1) VCR components that need to be connected.
(2) Male Nut and Female Nut are respectively set on the Gland, and then they are automatically welded to the TUBE to be connected.
(3) install metal gasket: if it is with claw gasket, clip the gasket onto the Gland (pay attention not to scratch the Gland sealing surface); If it is a claw less washer, insert the washer into the Female Nut.
(4) tighten the inner and outer nuts with fingers.
(5) mark the hexagon head of the inner and outer nut with a marking pen (as shown in FIG. 6).
(6) use a wrench to fix the nut with outer thread and another wrench to tighten the nut with inner thread 1/4 turn inward (i.e. 90 degrees).
文章出自江门艾瑞 转载请标明出处
VCR接头订购联系:秦先生 17688183787
江门艾瑞vcr接头生产厂家生产的vcr接头产品质量真的很好,已经合作过2年了。
跟很多家vcr接头贸易商合作过,但是自从跟艾瑞vcr接头生产厂家合作过就一直觉得比其他贸易商好,可以看到产品的质量差别。
公司需要316不锈钢材质的vcr接头,刚好遇到了艾瑞精密机械科技有限公司,其能够生产316材质的vcr接头,满足了公司的需求。
vcr接头的厂家在国内真的很少,一直合作的就是艾瑞精密机械科技有限公司了,公司生产的产品符合我司的要求。